Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 23.06.2025 05:38

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

He then describes Rainy Season and Lightning.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

This is 'the assistant's answer'

From the Desk of AD Laird Veatch: Mizzou Athletics Embarks on New Era With ‘Will to Win’ - University of Missouri Athletics

The bolt then partially travels down the line to your home.

In schematic diagrams this is the symbol for a fuse:

This is where this question deviates from being a 'generic' question, and becomes more specific.

New COVID-19 variant detected in Washington state, health officials say - KING5.com

A circuit breaker is similar, but is resettable.

but I think this circuit , shows a few more pieces.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

Is it possible for the U.S. government to get rid of the constitution for national safety?

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

What is lightning?

2024–10–14 [Omar Gharbi Omar Gharbi ]

How is cultural invasion being carried out by Bollywood?

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

First Sentence:

What is the opposite personality type of someone with ASPD (antisocial personality disorder)?

[old diagram got deleted by accident]

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

What is the best AI for interior designers?

One is “what exactly is in a ‘surge protector’ ? ”

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

Safeway workers begin striking in 4 Colorado cities - 9News

There are three different concepts here that are getting confused.

This one hit behind the barn.

This is where the MOV conducts again, and dissipated the energy.

6 "Bad" Foods that Could Actually Help Lower Blood Pressure, According to Dietitians - EatingWell

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

So, the voltage could go up to 500 volts, and the fuse will not open up.

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

Ultimate NBA summer trade guide: 100 players, split into 11 tiers, who could be dealt during 2025 offseason - CBS Sports

Upvotes:

I post the exact comment here.

Now when you have a certain ac resistance, then a current flows in a loop.

Kraken Deal Andre Burakovsky To Chicago - NHL.com

A fuse is a non-resetable over current circuit protector.

2024–10–10[John johnson John Johnson ]

For this case there are devices called Metal oxide varistors (MOV).

Nintendo Warns Switch 2 Owners Not to Remove Protective Screen Film - CNET

This device then solves the entire problem.

An AC voltage/ current source, and an ac inductive load.

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

He then describes the function of a fuse.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

Barnstars:

At one ohm, the resistor has a maximum of 1 watt power.

2024–10–16 [ OO OLAOYE OYEBODE ]

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

Edit 2024–10.

so, what happens?

It also is a device that limits the change in current flow.

the problem then depends on "how fast does the fuse operate?".

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

Because the load is inductive, the current lags the voltage.(by a bit).

eight

(Dc diagram shown, AC is similar).

The MOV will conduct when the voltage exceeds 50% of line voltage.

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

The third is lightning and “how it gets conducted into a home.”

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

What does a fuse do?

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

but this device (an Inductor) … impedes the rapid changes in the current.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

Here is a simplified AC power diagram.

what exactly is a ‘surge’ protector?

Can the fuse protect the electronic devices from lightning instead of a surge protector.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

These are simplified answers to the original question, and does not change anything I wrote above.

[image of Common-mode choke]

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

At least they know the answer if they wanted it.

He then asserts :

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

These devices are installed between the “hot” and “neutral” and protective ground.

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

The other is “what does a “fuse” do?”

There are two important concepts here.

nine

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

It seems Mohan does not understand the difference between a comment and an Answer.

But it can get overloaded, and no longer works.

a photo is worth a thousand words.

But… the neutral is now “floating” because of the 1 ohm resistance.

This is the picture of an electronic coil of wire wound around a core of magnetic material.

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

One